Honda

Honda V4 Cam-Chain Tensioner Removal & Installation

Posted on 28 November 2014

Download Honda V4 Cam-Chain Tensioner Removal & Installation – 1) Set the bike to Top Dead Center (TDC) 1-3 on the flywheel- Remove the alternator cover and use a 17mm socket wrench to spin the flywheel clockwise to TDC. This is the point at which the cylinder is at the top of it’s compression stroke […] Continue Reading

Comments (0)

Honda

2003-2007 Honda CBR954RR Undertail Kit Installation

Posted on 27 November 2014

Download 2003-2007 Honda CBR954RR Undertail Kit Installation – 1) Carefully remove the tail section body work. Save all bolts, washers and plastic rivets for re-installation of tail. Disconnect and remove the brake light (with all mounting grommets and washers), license plate and turn signals, key lock (with clip) and move all wiring out of the […] Continue Reading

Comments (0)

Honda

2008 Honda CBR 600RR Dual Canister Slip-On Installation

Posted on 26 November 2014

Download 2008 Honda CBR 600RR Dual Canister Slip-On Installation – 1. Insure the exhaust system and exhaust Components are fully cooled. 2. Insure the motorcycle is stable on Kickstand or rear centerstand or Service table. 3. Remove both the front and rear seats. 4. Remove the 4 bolts holding the tail Fairing to the subframe […] Continue Reading

Comments (0)

Honda

Honda XR600/XR650L Camshaft Removal and Installation

Posted on 26 November 2014

Download Honda XR600/XR650L Camshaft Removal and Installation – Remove the tappet covers. Remove the crankshaft cap and timing hole cap on the left engine case cover. Remove the spark plug. Rotate the engine in a counter clockwise direction. Position the engine at true top dead center (TDC) using the mark on the flywheel. True top […] Continue Reading

Comments (0)

Chrysler

2005 PT Cruiser & SRT-4 Engine Torque Strut Replacement

Posted on 25 November 2014

Download 2005 PT Cruiser & SRT-4 Engine Torque Strut Replacement – 1. Remove pencil strut. See Fig. 2 . Loosen upper and lower torque strut attaching bolt at suspension crossmember and shock tower bracket. Engine position may now be adjusted by positioning a suitable floor jack on the forward edge of transmission bellhousing. See Fig. […] Continue Reading

Comments (0)

Dodge

2009 Truck RAM P Code Charts P2122 Service Proedure

Posted on 25 November 2014

Download 2009 Dodge Truck RAM 1500 P Code Charts P2122 Service Proedure – WHEN MONITORED: With the ignition on and no other APPS No.1 DTCs present. SET CONDITION: When the APP Sensor No.1 voltage is too low. Engine will additionally idle if the brake pedal is pressed or has failed. Acceleration rate and Engine output […] Continue Reading

Comments (0)

Chrysler

Door Trim Panel Caravan, Town & Country, & Voyager

Posted on 25 November 2014

Download Door Trim Panel Caravan, Town & Country, & Voyager – Removal & Installation 1. Remove the plug and remove screw attaching door pull cup to inner door panel. 2. Remove switch bezel and disconnect power window/memory switch. 3. Remove screws attaching trim panel to door from below map pocket. 4. Remove screw holding door […] Continue Reading

Comments Off

Chrysler

2005 Chrysler Town & Country Brakes Anti-Lock Bleeding

Posted on 24 November 2014

Download 2005 Chrysler Town & Country Brakes Anti-Lock Bleeding – ABS BLEEDING NOTE: Diagnostic Readout Box (DRB-III) is necessary to properly bleed Teves Mark 20 anti-lock brake system. 1. Ensure all hydraulic brake system components are properly installed and all connections are tight. Using scan tool, check Controller Anti-Lock Brake (CAB) for faults. If any […] Continue Reading

Comments Off

SEE MORE ARTICLES IN THE ARCHIVE